Engines - Fuel System (GE) 
Fuel is supplied under pressure by fuel pumps located in the fuel tanks. The fuel flows through a spar valve, located in the main tank. It then passes through the first stage (low-pressure) engine fuel pump where additional pressure is added. The fuel is then managed as follows:
Final pressure is generated by a second stage (high-pressure) fuel pump.
The fuel is then heated automatically by engine oil as it flows through the fuel/oil heat exchanger.
A fuel filter then removes contaminants.
The fuel is then controlled by the Fuel Metering Unit to meet existing thrust requirements.
The fuel flows through the Engine Fuel Valve and Fuel Flow Meter.
The fuel enters the engine combustion chamber.
Fuel Control Unit
The engine fuel control system incorporates a hydro-mechanical fuel control unit, which operates in conjunction with the EEC. The fuel control system schedules fuel flow to meet engine thrust requirements as dictated by the thrust lever position and the specific engine operating conditions. The EEC trims the metered fuel to prevent overspeed when operating at or near engine limits.
Engine and Spar Valves
The Spar Valve located in the main fuel tank and the Engine Valve located in the Fuel Control Unit allow fuel to flow to the engine when the both valves are open. The valves open when the Engine Fire Switch is IN and the Fuel Control Switch is in the RUN position. Both valves close when either the Fuel Control Switch is at CUTOFF or the Engine Fire Switch is OUT.
The ENG VALVE and SPAR VALVE lights will illuminate momentarily as the valves open or close. If the valves do not agree with the Fuel Control Switch or the respective Fire Switch position after allowing for normal operating time, the lights remain illuminated and the EICAS advisory message L/R FUEL SPAR VAL(VE) or L/R ENG FUEL VAL(VE) displays.
Fuel Filters
The fuel is filtered by two [High and low-pressure] filters. If the first [low-pressure] filter becomes clogged with contaminates, fuel will bypass the filter allowing contaminated fuel to enter the control unit.
(SB changes Advisory message to Status message)
The EICAS status message L/R ENG FUEL FILT displays to indicate the affected engine filter is clogged and is approaching a level sufficient to cause filter bypass.
Erratic engine operation and flameout may occur due to fuel contamination. The purpose of the second (high-pressure) fuel filter located downstream of the fuel flow governor is to catch debris from a deteriorating second stage (high-pressure) fuel pump.
Fuel Flow Measurement
Fuel flow is measured after passing through the Engine Fuel Valve. Fuel flow is displayed on the secondary engine display. Fuel flow information is also provided to the FMS for Fuel Used and Fuel Remaining calculations. PROGRESS PAGE 2
